Cross Tweezer curved on stand - heat resistant Selfholding Tweezer. Hols small objects by itself

Hand drill with spring For drills from 0.3-1,0mm

Scriber set - 4 pieces Different shapes hooks

Hand drill / vice For drills from 0.3 - 1.0mm

Needle file set - 3 Pcs.

Magnifying glasses with 3 glasses Magnifying: 1.5x, 2.5x, 3.5x

Diamond Burs  Spherical - 15 pcs. 4 x Ø 1,5 mm 4 x Ø 2,0 mm 3 x Ø 3,0 mm 2 x Ø 4,0 mm 2 x Ø 5,0 mm Ideal for Proxxon, Dremel and comparable machines.

Brass Vice

Hammer with 6 changeable heads 1x Flat - Synthetic 1x Flat - Brass 1x Flat - Steel 1x Rivet - Steel 1x Ball - Steel 1x Round - Steel

6-piece rubber polishing burr set Rubber polishing points for finishing and for polishing metal, alloys, ceramics, tiles, stone, glass, plastic and fiberglass. To be used with Proxxon, Dremel and other milling machines. Width of the tips approx. 6mm. Cont

Hand drill with spring - Large With extra collet For drills from 0.3-1.5mm

Tin snips To cur thin metal sheets and photo etch.

Bench hook with miter box The raised edge can be used as a stop for a workpiece. In the raised edges, 2 mini miter boxes are incorporated, these can be used with the middle and largest saw blade https://www.marks-miniatures.com/en/handsaw.html Material:

Mitre box aluminium For metal saws and precision saws.

Drill set 2.35 mm shank- Cobalt Cobalt drills specially for hard steel alloys. e.g. V2A (Stainless Steel) 0.6mm, 0.8mm, 1.0mm, 1.3mm, 1.5mm, 2.0mm.

Fret saw set, fret saw set: fret saw table and G-clamp

Vice deluxe - Large Vice: Aluminium Pins: 4 Normal objects can be clamped between the two halfs. The Pins could be used to clamb round and uneven objects.

Brass Brush cleaning pin For cleaning the connection areas on circuit boards, cleaning contacts of all kinds, removing residues on metal templates. In plastic modelling used to sand over applied glue on models. When in use, only the tip of the...

Parallel clamp 50mm Can apply pressure to your workpiece along its entire length, or aimed at a specific point. Total length of the jaw: 50mm - Usable jaw length: 20mm (the part of the jaw that is in front of the spindles) - Clamping range in the width:

Tap Wrench Mini Square: 2,1-6,0mm Length approx. 11 cm

Brass vice

Double hand drill / vice Length: ca. 9cm For drills from 0.3 - 2.4 mm with 2 double collets (=4 different sizes) with 2 double collets (=4 different sizes)

Hobby Rivet Maker for making rivet impressions in plastic With 4 different blades. Spacing between tips from approx. 0.5mm (blade A) to 1.75mm (blade D)

Machinist Square with stop Size ca.50x75mm