Bending and forming

Bending tool 6.0-10.0mm

For bending and forming from wire and metal strips/pieced(photo etch).
Due sepperate sizes, you are allowed to bend repeatly with the same curve

Size:6.0/7.0/8.0/9.0/10.0 mm

Bending tool 1.5-5.0mm

For bending and forming from wire and metal strips/pieced(photo etch).
Due sepperate sizes, you are allowed to bend repeatly with the same curve

Size:1.5/2.5/3.5/4.5/5.0 mm

Photo Etched parts Bender (Small) with two bending aids.

Has been specially developed for model building using photo etch parts allowing the brass to be held and bent accurately into many different shapes.

Measures 59mm x 59mm

Photo Etch Pencil
Has a slightly sticky tip, to pick and place small parts without shooting away.

If the tip is not sticky or sharp anymore it can be scharpened with a regular pencil sharpener.

Photo Etched parts Bender (Large) with 4 bending aids.

Has been specially developed for model building using photo etch parts allowing the brass to be held and bent accurately into many different shapes.

Measures 79mm x 162mm

Bending springs for tubes

For evenly bending brass, copper and tubes without kinking.

Beforehand, the part of the tube to be bent must be softened by heating it with a flame. Then let the tube cool down. After cooling, the bending can begin.

Meth

Doming punch set with doming block

12 doming punches in the sizes: 2.3 - 3.5 - 4.3 - 5.1 - 5.9 - 6.7 - 7.5 - 8.3 - 9.1 - 9.9 - 10.7 - 11.5mm.

Manufactured from hardened tool steel

Doming block:
Manufactured from hardened and polished tool steel