Sawblade for hobby knife #1

Hammer Rubber/Steel Hammer with rubber and steel head

Vice deluxe Vice: Aluminium Pins: 4 Normal objects can be clamped between the two halfs. The Pins could be used to clamb round and uneven objects. Maximum opening halfs:25mm Maximum opening between pins:30mm

Tin snips To cur thin metal sheets and photo etch.

Bench hook with miter box The raised edge can be used as a stop for a workpiece. In the raised edges, 2 mini miter boxes are incorporated, these can be used with the middle and largest saw blade https://www.marks-miniatures.com/en/handsaw.html Material:

Plier round nose

Mini clamp on stick

Machinist Square with stop Size ca.50x75mm

Fret saw set, fret saw set: fret saw table and G-clamp

Center Punch Set 1/32 Inch 1/16 Inch 3/32 Inch

Mini scissors

Needle nose pliers straight fine

Machinist Square Size ca.68x102mm

Professional Scalpel handle no.4 Swann Morton (without blade)

Brass brush set - 3 pcs. Straight brush Ø 5mm Disc brush Ø 22mm Cup Brush Ø 15mm Shaft/pin thickness 3.1mm Ideal for Proxxon, Dremel and similar devices.

Clay loop tool set 16 cm - 10 pieces. - premium Sturdy sculpting tool with loops in various shapes. Suitable for removing excess material or for hollowing out. Total length: approx. 16 cm

Drill set 2.35 mm shank- Cobalt Cobalt drills specially for hard steel alloys. e.g. V2A (Stainless Steel) 0.6mm, 0.8mm, 1.0mm, 1.3mm, 1.5mm, 2.0mm.

Mini clamp

Rubber block For punching and cutting Size: 50x50x25 mm

Circular saw blade for wood and plastic. Diameter: 22mm Thickness: 0.3mm Fixing hole: 1.7mm

Parallel clamp 50mm Can apply pressure to your workpiece along its entire length, or aimed at a specific point. Total length of the jaw: 50mm - Usable jaw length: 20mm (the part of the jaw that is in front of the spindles) - Clamping range in the width:

Plier tweezernose

Circlip pliers 2x 180º 1x 90º 1x 45º

Mini collet holder with 3 collets For example to hold small dills in bigger drill chucks 3 Collets: 0-0.8MM 0.8-1.5MM 1.5-2.5MM