Sandpaper file 100/180 grit curved Side 1: 100 grit Side 2: 180 grit 19mm wide 5mm thick with foam filling Approx. 18cm long.

Hobby Rivet Maker for making rivet impressions in plastic With 4 different blades. Spacing between tips from approx. 0.5mm (blade A) to 1.75mm (blade D)

Scriber used for marking metals and plastics. also usable as center punch

Hand drill / vice For drills from 0.3 - 1.0mm

Ruler - metal Scale: mm and inch Reach: 15,5 cm / 6 inch

6-piece rubber polishing burr set Rubber polishing points for finishing and for polishing metal, alloys, ceramics, tiles, stone, glass, plastic and fiberglass. To be used with Proxxon, Dremel and other milling machines. Width of the tips approx. 6mm. Cont

scraping-knife For scaping and deflash plastics and metals.

Bending tool 1.5-5.0mm For bending and forming from wire and metal strips/pieced(photo etch). Due sepperate sizes, you are allowed to bend repeatly with the same curve Size:1.5/2.5/3.5/4.5/5.0 mm

Hand vice with wing nut 130 mm Flat clamp 11mm wide. For clamping small objects

18-piece grinding disc set. Resin bonded aluminum oxide discs for grinding, cutting and deburring. Can be used on metal, alloys, plastic, fiberglass and wood. To be used with Proxxon, Dremel and other grinder machines. Cutting disk is 0,6mm strong Content

Hammer Nylon/Brass Hammer with nylon and brass head

Hand drill with spring For drills from 0.3-1,0mm

scraper/knife with handle

7-piece rubber grinding discs set - slightly abrasive Rubber grinding wheels for cleaning and polishing metal, alloys, ceramics, tiles, stone, glass, plastic and fiberglass. Can be used on Proxxon, dremel and other milling machines. Disc size 3.2x22mm Con

Drill set 2.35 mm shank- Cobalt Cobalt drills specially for hard steel alloys. e.g. V2A (Stainless Steel) 0.6mm, 0.8mm, 1.0mm, 1.3mm, 1.5mm, 2.0mm.

Spring divider large For circles up to 31,5cm

Brass Brush for cleaning various surfaces

Machinist Square Size ca.57x77mm

Machinist Square Size ca.50x75mm

Milliput is one of the best known epoxy putty products for modeling. Milliput also consists of two components and by mixing well (5 min. Good kneading) the material will slowly harden, after which it is fully cured after 3 hours. By keeping the putty cool

Hobby Line Engraver for making panel lines (seams) in plastic

9-piece grinding disc set Silicon carbide grinding wheels, with a width of 3mm, for sharpening, grinding, deburring, rust removal and sanding, etc. Can be used on metal, alloys, ceramics, tiles, stone, glass, plastic, fiberglass and wood. Compatible with

Knife blade 4 mm- 12 Pcs.

Hammer Rubber/Steel Hammer with rubber and steel head